Guard Tour; Osdi Zones - Axis Q6032-E User Manual

Enter the limits (in degrees) of the Lower tilt angle and Upper tilt angle, or click the links and move the blue horizontal bars
in the preview window. To set the pan limits, enter the values (in degrees) in the Pan Limit Start and Pan Limit End fields, or
click the links and move the blue vertical bars in the preview window. Auto tracking is allowed between the pan start and end
limits going clockwise, see the illustration below.

Guard Tour

A guard tour displays preset positions, one-by-one, in a pre-determined order or at random, and for configurable time periods.
Once a preset position has been set and added to the guard tour, the following settings can be made:
• Pause between runs
• Move Speed - sets the speed of the Pan/Tilt movements to the preset position
• View Time in seconds or minutes
• View Order (or Random)

OSDI Zones

On-screen Direction Indicator (OSDI) Zones can be included in the overlay text to aid the user to navigate the camera. Each
OSDI Zone is set up with coordinates and a descriptive name.
The camera uses the coordinates of the center of the image to set the lower left and upper right zone areas. First navigate to
where you would like the lowermost left point of the OSDI Zone to be located. By clicking the Get button the coordinates are
set. Proceed to where the upper right point of the zone should be located and click its Get button. Give the zone a descriptive
name and click Ok. See Overlay Settings, on page 19, for information about including the name of the OSDI Zone in the
overlay text.
Advanced
Limits
Define the pan, tilt, zoom and focus limits for the AXIS Q6032-E. Movements to the left and right, up and down, can be
restricted to narrow the area under surveillance. The near focus limit can be set to avoid focusing on objects too close to the
camera.
Once a limit has been saved, this position cannot be exceeded by the AXIS Q6032-E unless the values have been reset and
saved to a greater value first (reset the default values of the mechanical restrictions).
Move speed sets the speed of the camera's Pan/Tilt movements. The default setting is maximum speed.
Top view
Auto tracking allowed
22
AXIS Q6032-E - Dome