Parameter Settings; Adjust The Time And Date; H-Meter 1 - Nederman L-PAK Series Manual

6.2

Parameter settings

The following PLC displays show the different settings that can be configured for the unit.
6.2.1

Adjust the time and date

NEDERMAN
Hi Vacum Unit
L-PAK Standard
OFF
TimeTo Service
2000 Hours
Msg Config >
Start Screen >
Clock >
LCD >
Menu Language >
Switch to OP
Do the following to adjust the time and date:
1. From a PLC status screen, press the down arrow
2. Press 'Escape'
3. Press the down arrow
4. Press the down arrow
5. Press the down arrow
6. Use the left and right arrows
to confirm.
OK
7. Use the up or down arrows
Weekday is automatically set by the date.
8. Press 'Escape'
9. Press the up arrow
NOTE! There are several other input menus on the same level as the date and time screen.
If pressing the down arrow
get to the date and time screen.
6.2.2

H-Meter 1

Menu for setting the service interval. The default value is 2000 hours.
H-Meter 1/1
MI =2000h:0m
OT =0h:15m
MN =1999h:45
MN Ext =2000
ESC OK
Thu 10:45
2018-02-01
ESC OK
Set Clock
S/W time
Sync
ESC OK
to get to the main menu.
ESC
to go to 'Setup'. Press 'OK'
to go to 'Clock'. Press 'OK'
to go to 'Set Clock'. Press 'OK'
to move to cursor to parameter value. Press 'OK'
to set Time or Date. Press 'OK'
3 times to go to the time screen.
ESC
to exit.
takes the PLC to one of those menus, use the left arrow
MI = Configured, time, between, maintenance interval
OT = Accumulated, total operating time
MN = Time left until next maintenance
MI = 2000h: The amount of time between service intervals.
MI = 2000h: The amount of time between service intervals.
L-PAK 150/250 Standard
Stop
Program
Setup
Network
Diagnostics
ESC OK
> Set Clock
>
> Thu 10:45
2018-02-01
ESC OK
to go to the date and time screen.
to confirm.
OK
to confirm.
OK
to confirm.
OK
>
>
>
>
>
ESC OK
ESC OK
to confirm.
OK
to
EN
13