Unit Connectors - Axis M1054 User Manual

Unit connectors

Network connector - RJ-45 Ethernet connector. Shielded cables recommended.
Power connector - Mini DC connector 5.0-5.1V DC, Max 1.5A. Center pin +.
I/O terminal connector (AXIS M1054 only)
The 4-pin I/O terminal connector provides the interface to:
• 1 transistor output
• 1 digital input
• auxiliary power
• GND
The terminal connector is used in applications for motion detection, event triggering, alarm notification via email, and image
storage to FTP locations.
• Input - for connecting a push button, for example. If the push button is pressed, the state changes and the input becomes
active (shown under Events > Port Status).
• Output - connects an alarm device that can be activated by Output buttons on the Live View page, or by an Event Type.
The output shows as active (Events > Port Status) if the alarm device is activated.
Function Pin Notes
GND 1 Ground
3.3V DC Power 2 Can be used to power auxiliary equipment.
Note: This pin can only be used as power out.
Digital Input 3 Connect to GND to activate, or leave floating (or unconnected) to deactivate.
Transistor Output 4 Uses an open-drain NFET transistor with the source connected to GND. If used
with an external relay, a diode must be connected in parallel with the load, for
protection against voltage transients.
Connect input/output devices to the camera as follows:
1. Attach the cables for the device securely to the supplied connector block.
2. Once the cables are connected, connect the connector block to the terminal connector on the camera.
AXIS M10 Series - Product Description
I/O connector
Pin 4
Pin 3
7
Pin 2
Pin 1