Axis M1054 User Manual page 37

Use NAT traversal when your network camera is located on an intranet (LAN) and you wish to make it available from the
other (WAN) side of a NAT router. With NAT traversal properly configured, all HTTP traffic to an external HTTP port in the NAT
router is forwarded to the camera.
LAN (intranet)
Notes:
• For NAT traversal to work, this must be supported by the broadband router.
• The broadband router has many different names: "NAT router", "Network router", Internet Gateway", "Broadband
sharing device" or "Home firewall" but the essential purpose of the device is the same.
Enable/Disable - when enabled, the network camera attempts to configure port mapping in a NAT router on your network,
using UPnP™. Note that UPnP™ must be enabled in the camera (see System Options > Network > UPnP).
Use manually selected NAT router - select this option to manually select a NAT router and enter the IP address for the router
in the field provided.
If a router is not manually specified, the network camera automatically searches for NAT routers on your network. If more
than one router is found, the default router is selected.
Alternative HTTP port - select this option to manually define an external HTTP port. Enter the port number in the field
provided. If no port is entered here a port number is automatically selected when NAT traversal is enabled.
Notes:
• An alternative HTTP port can be used/be active even if NAT traversal is disabled. This is useful if your NAT router does
not support UPnP and you need to manually configure port forwarding in the NAT router.
• If you attempt to manually enter a port that is already in use, another available port is automatically selected.
• When the port is selected automatically it is displayed in this field. To change this enter a new port number and click
Save.
FTP -
The FTP server running in the network cameras enables the upload of new firmware, and user applications. Check the
box to enable the service.
RTSP -
The RTSP protocol allows a connecting client to start an H.264/MPEG-4 stream. Check the box to enable the server
and enter the RTSP port number to use. The default setting is 554. Note that H.264/MPEG-4 video streams will not be
available if this service is not enabled.
Wireless (AXIS M1011-W/AXIS M1031-W only)
Wireless settings in the AXIS M1011-W/AXIS M1031-W must be the same as the access point or ad-hoc device. When
changing the settings, they should always be made first in the camera and then in the wireless access point. This ensures that
the camera is always accessible when making changes.
Status of Wireless Networks
This list is the result of a network scan. Access points with a disabled SSID Broadcast will not appear unless the camera is
linked to it. The network the AXIS M1011-W/AXIS M1031-W is currently linked to is shown in blue. A network using
unsupported security is shown in grey. The following information is provided:
Broadband
(NAT)
router
37
AXIS M10 Series - System Options
WAN (internet)
ISP