Setting The Root Password; Access From The Internet - Axis M1054 User Manual

Setting the root password

1. When accessing the camera for the first time, the 'Configure Root Password' dialog appears.
2. Enter a password and re-enter to confirm. Click OK. The
Enter Network Password dialog appears.
3. Enter the User name: root
4. Enter the password set in step 2, and click OK. If the
password is lost, the camera must be reset to the factory
default settings. See page 42.
Notes:
• The default administrator user name 'root' is permanent
and cannot be deleted.
• While setting the root password, click Yes to install the
AXIS Media Control (AMC), if you are prompted to. If
required, click the link to install missing decoders. You
will need administrator rights on the computer to do
this.

Access from the Internet

Once connected, the camera is accessible on your local network (LAN). To access the camera from the Internet you must
configure your broadband router to allow incoming data traffic to the camera. To do this, enable the NAT-traversal feature,
which will attempt to automatically configure the router to allow access to the camera. This is enabled from Setup > System
Options > Network > TCP/IP Advanced.
For more information, please see "NAT traversal (port mapping) for IPv4" (page -36). See also the AXIS Internet Dynamic DNS
Service at www.axiscam.net For Technical notes on this and other topics, visit the Axis Support web at www.axis.com/techsup
AXIS M10 Series - Accessing the Camera
10