Table of Contents
Advertisement
N61e V1.0 or Higher
Three steps are needed to create a new battery memory. First, program the
battery type. Second is the capacity. And third, the cells number (S). Then the
charger will complete the batteries parameter and make up a new battery
memory.
STEP1 TUPE
LiPo
STEP2 CAPACITY
1000mAh
STEP3 CELLS
3S
A LiPo3S 1.00Ah
▊
STD CHG
+1.0A
You can EXIT from the configuration at any step but it will fail to create a
new Batt.M.
SETTING SYSTEM PARAMETER
Several parameters of the system can be programmed in SYSTEM
PARAMETER. You can refer Table SYSTEM PARAMETER to make some
adjustments.
Table. SYSTEM PARAMETER
TEMP UNIT
CUT OFF
KEY BEEP
BUZZER
INPUT
TRICKLE
Select the Battery Type
Set the Capacity
Number of cells
C/F (℃/℉)
55～66℃ or 50～150℉
ON/OFF
MELODY1～5
11.0VDC～13.5VDC
ON/OFF
17/23
Advertisement
Table of Contents
