Handling Instructions For Lithium Batteries; Lipo & Li-Ion Battery Summary; Li-Fepo4 Batteries /A123 Summary; Edit Batt.m For Your Lithium Batteries - Flash N61e Instructions Manual

N61e V1.0 or Higher
HANDLING INSTRUCTION FOR Lithium Battery
LiPo & Li-ion Battery Summary
Nominal voltage: LiPo 3.7V/cell. Li-ion 3.6V/cell
Max charge voltage: LiPo 4.2 V ±50mV. Li-ion4.1 V±50mV.
Min discharge voltage: 3.0V.
Recommended charge current: 1C. (UP to 2C for partial batteries)
Recommended Protective Temperature: 55°C
Long time storage: 3.8V/cell with about 30～50% SOC (state of charge).
*Note: The parameters shown above are fit for most LiPo or Li-ion Batteries.
But it's very strongly recommended to reference the battery handbook which
is published by the manufacturer. There are some major differences between
them..

Li-FePO4 Batteries /A123 Summary

Nominal voltage 3.3V/cell
A123 is produced by A123 Company. It's an excellent Li-FePO4-type. The
following descriptions only represent A123:
Nominal capacity 2.3Ah
Recommended constant current: 3A
Maximum continuous charge current: 10A
Max charge voltage: 3.6V@3A, 4.2V@10A
Recommended charge time: 45 minutes@3A, 15 minutes@10A.
Min discharge cut‐off voltage: 2.0V/cell
Recommended Protective temperature: 60°C
Edit Batt.M to suit your Lithium Batteries.
In any Batt.M, rotate the dial to page up and down and you can skim the
battery parameters. Press the dial to start editing parameters. The editing
parameter will flash. Then rotate the dial to find your desired value. Re-press
to confirm it. Except for the last term, the next parameter will be allowed to
be edited at once. After editing the last item in one page the system will auto
8/23