Table of Contents
Advertisement
N61e V1.0 or Higher
stop the editing function.
Just press the dial briefly (5 sec) to start charging or discharging with the
Memory you have just created.
Pressing the EXIT button will stop the editing function. Re pressing EXIT
will allow you to exit from the Batt.M.
Whenever you find a suit Batt.M or have just created a new one please
confirm Par1 ... Par7 again before you start to charge/discharge lithium
batteries. The remaining, Par8...Par11, offer some information about the
battery or the charge to you. The following description will help you to
realize the full implications of them.
Par1. Battery Type
While similar in many ways, lithium -
polymer and lithium-ion battery types
perform a little differently. The LiFePO4
is
quite
different
with
necessary to select the proper type
for safe operation.
Par2. Number of Cells in Series
Wrong setting for this parameter will cause permanent damage to your packs
or charger and surroundings. It allows adjustment from 1 to 6 cells. The unit
is 'S' which means cells in series.
Table. Number of Lithium Cells in Series
Nu
m
1S
Type
3.7V
7.4V
LiPo
3.6V
7.2V
Li-ion
3.3V
6.6V
Li-FePO4
Par3. Capacity
Capacity is a very important parameter for N61e. This parameter will work
on the operating control. It's mostly obvious that it determines the charge
current at FAST/ STD/ SLOW/STG function. The charge rate is fixed. But
the actual value is determined by the capacity you set.
Par4. Optional Function & Operating Current
A LiPo3S 4.50Ah
▊
STD CHG
them.
It's
Page.1 (Par1/2/3/4)
2S
3S
4S
11.1V
14.8V
10.8V
14.4V
9.9V
13.2V
9/23
+4.5A
5S
6S
18.5V
22.2V
18.0V
21.6V
16.5V
19.8V
Advertisement
Table of Contents
