Security Slot; Hardware Specifications; Radio Specifications - Extreme Networks AP410C User Manual

AP410C Hardware Guide
the button. To reboot the device, press the button for 5 seconds. To return the configuration to the factory default settings, press it for at least 10
seconds. After releasing the button, the indicator light goes dark, and then glows steady amber while the firmware loads and the system per-
forms a self-test. After the software finishes loading and the AP has connected to ExtremeCloud IQ, the status indicator glows steady white.
To prevent the reset button from resetting the configuration, enter this command:
no reset-button reset-config-enable
When this command is enabled, pressing the button for 5 seconds will still reboot the AP, but pressing it for more than 10 seconds will not reset its
configuration.

Security Slot

The AP410C has a security slot for locking the device.
Extreme Networks recommends a variety of Kensington

Hardware Specifications

The following sections list radio, device, power, and environmental specifications for the AP410C.

Radio Specifications

Radio 1: 5 GHx 2x2 band 1 and 2 + 2.4 GHz 2x2
l
Radio 2: 2.4 Hz 1x1+ 5 GHz 1x1 (scanner)
l
Radio 3: 5 GHz 4x4 full band or 5 GHz band 3 and 4
l
Operating Frequency:
2402 - 2483.5 MHz for the 2.4 GHz radio
l
5150-5850 MHz for the 5 GHz radio
l
Wi-Fi Channel Support
WiFi 2.4G RX requirement: -96dBm@1Mbps
l
WiFi 5G RX requirement: -93dBm@6M
l
Bluetooth BLE Beacon (BLE 5.0)
2402 - 2480 MHz
l
Frequency Hopping Spread-spectrum (FHSS) 802.11a
l
5150-5250, 5725-5850 MHz operating frequency
l
Orthogonal Frequency Division Multiplexing (OFDM)
l
modulation
Rates (Mbps): 54, 48, 36, 24, 12, 9, 6 with auto fallback
l
802.11b
2.4-2.48 GHz operating frequency
l
Direct-Sequence Spread-Spectrum (DSSS) modulation
l
Rates (Mbps): 11, 5.5, 2.1 with auto fallback
l
802.11g
2.4-2.48 GHz operating frequency
l
Orthogonal Frequency Division Multiplexing (OFDM)
l
modulation
Rates (Mbps): 54, 48, 36, 24, 12, 9, 6 with auto fallback
l
802.11n
5 GHz 5150-5250, 5725-5850 MHz operating frequency
l
802.11n modulation
l
Rates: MCS0 - MCS7
l
2x2 MIMO radio
l
HT20/HT40 support (HT40 is for 5 GHz only)
l
A-MPDU and A-MSDU frame aggregation
l
AP410C Hardware Guide
®
locks. For more information, contact your sales representative.
7
7