AEG ME09 Installation, Operation And Maintenance Manual page 36

2.1
2.1.1
2.1.2 LCD
2.1.3
无：接通装置电源。在释放单元上完成。
2.1.4
ME09 5000-6400A
SET UP
METER
STATUS
EVENTS
2.1-03
INTRO BREAKER
TRIP UNIT
2.1
2.2
LOCKS ACCESSORIES
2.1 Product descrip on
2.1.1 Appearance
The Trip Unit includes a graphical LCD. The front panel being
similar to that depicted in Figure
2.1. Normally the device is set to the English language,
op onally French, German, Spanishor Chinese can be selected.
2.1.2 LCD ACCESS
The trip unit has ve func on keys as shown in Figure 2.2. Any
key, when pressed, powers up the LCD.
All SETUP, STATUS, METER and EVENTS informa on is accessed
through these ve keys.
-- UP: Scroll up or increment value
-- DOWN: Scroll down or decrement value
-- RIGHT: Next func on or next page
-- LEFT: Previous func on or previous page
-- ENTER: Save or set in to memory
2.1.3 Electrical Requirements
None: Plug in installa on. Done on de-energized units.
2.1.4 Equipment Interfaces
ME09 5000-6400ACircuit Breakers.
Trip units, for the most part, do not require direct connec ons to
the equipment. All wiring is intended to connect to the circuit
breaker or casse e.
Connec ons that are required for other equipment are the
op onal zone-selec ve interlock, relay in-output and the neutral
sensor, which uses speci cally dedicated connec on
points on the breaker secondary connec on terminals.
A signal Input (nr.1) can be programmed to allow for the use of
reduced instantaneous (RELT) or to trip the breaker. A second
input (nr.2) can be set to 'OFF' or programmed to trip
the breaker only.
Fig. 2.1
LCD screen
Ba ery Compartment
KEY pad
AUTO/MAN reset choice
Full Range Ra ng Plug
Fig 2.2 Key pad
Up
Down
Right (Next)
Le (Previous)
Enter (Save)
TESTS APPENDIX