Valor GV60 NTK Operation Manual

Operation Manual
GV60 NTK Non-Thermostatic Remote Control
For Valor GV60 PLUS or MAX* Remote Control Systems ONLY
Non-Thermostatic Handset
The handset GV60NTK is used with the Valor GV60 PLUS
or MAX* receivers to turn the fi re ON or OFF and to set
the fl ame height. It has no thermostat or programming
functions. The handset shows the current time and the
room temperature.
Note
The handset GV60NTK does not operate the fan
control nor the lighting control.
Current room
temperature
Current time
Valor
logo
only
G6R-H3D6
Note
Synchroninizing the receiver again with a
thermostatic handset will reactivate the
thermostat, programming and auxiliary functions.
4003044-07
© Copyright Miles Industries Ltd., 2020.
GV60 NTK
The non-thermostatic
(NT) handset is
identified with a Valor
logo only. It shows
the current time and
room temperature. The
number shown on its
back cover label is G6R-
H3D6
Back cover label
Synchronize Remote Control
The receiver and the handset of the remote control sys-
tem must be initially synchronized before the fi rst use.
1. Insert alkaline batteries
in the remote control
battery holder and hand-
set. The battery holder
is located beside the
receiver, near the control
valve under the fi rebox,
left of the fi rebox or be-
side the wall switch.
2. With a sharp object, press and hold the receiver's
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 sec-
onds, press the small fl ame button
( ) on the remote handset until
you hear two short beeps confi rm-
ing the sychronization is set. If you
hear one long beep, this indicates
the code learning sequence has
failed or the wiring is incorrect.
This is a one time setting only and
is not required when changing the
batteries in the remote receiver. The
remote control system is now ready
to use.
1