Advertisement
Quick Links
The GV60 MAX Electronic Ignition Remote Control
system is used on the Valor heaters
Remote Control Initial Set-up
The receiver and the handset of the remote control sys-
tem must be initially synchronized before the rst use.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the control valve under the burner module.
2. With a sharp object, press and hold the receiver’' s
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 seconds, press the small
ame button (
) on the remote handset until you
hear two short beeps con rming the sychronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
July 2012
GV60 MAX
O
PERATING
models 700, 780 and 785
I
NSTRUCTIONS
1
Advertisement
Related Manuals for Valor 700
Summary of Contents for Valor 700
- Page 1 GV60 MAX PERATING NSTRUCTIONS The GV60 MAX Electronic Ignition Remote Control system is used on the Valor heaters models 700, 780 and 785 Remote Control Initial Set-up The receiver and the handset of the remote control sys- tem must be initially synchronized before the rst use.
-
Page 2: Remote Control Operation
Remote Control Operation NOTE: Before using the remote control system for IMPORTANT: BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature and the fi rst time, the receiver and the handset must be automatic ON/OFF can only be programmed when synchronized. -
Page 3: Modes Of Operation
•• Press and hold (small ame) MODES OF OPERATION button to decrease ame height or •• Brie y pressing the SET button to set the appliance at pilot ame. changes the mode of operation in •• For ne adjustment tap the the following order: (large ... -
Page 4: Circulating Fan Operation
•• - Nighttime Setback TO OPEN AND CLOSE DOUBLE BURNER T E M P (785 replace models only) Temperature Mode (Appliance must be in standby mode; pilot NOTE: The rear part of the double burner cannot be ac- ignited) - The room temperature tivated manually: it can only function with the re- is measured and compared to the mote control. -
Page 5: Setting The On / Off Temperatures
SETTING THE ON / OFF TEMPERATURES SETTING THE “NIGHTTIME SETBACK” SETTING THE “DAYTIME” TEMPERATURE TEMPERATURE Default Settings: (sun), 23ºC / 74ºF Default Settings: (moon), “ ” (OFF) TEMP T E M P •• Brie y press SET button to scroll to ••... - Page 6 SETTING PROGRAM TIMERS SETTING P1 OFF TIME •• You can program two periods of time between 12:00 •• Brie y press SET button to scroll am and 11:50 pm in each 24-hour cycle. to TIMER (moon) while the •• The Programs P1 and P2 must be set in the time ...
- Page 7 5 days. Because our policy is one of constant development and improvement, details may vary slightly from those given in this publication. Miles Industries Ltd. 190––2255 Dollarton Highway, North Vancouver, BC, CANADA V7H 3B1 Tel. 604-984-3496 Fax 604-984-0246 www.valorfi replaces.com...