Valor GV60NTK Operation Manuals

OPERATION MANUAL

For use with Valor GV60 PLUS or MAX* Remote Control Systems ONLY
Non-Thermostatic Handset
The handset GV60NTK is used with the Valor GV60
*
PLUS or MAX receivers to turn the fi re on or off
and the set the fl ame height. It has no thermostat or
programming functions. The handset shows the current
time and the room temperature.
*
NOTE: The handset GV60NTK does not operate
the fan control, the lighting control or the duplex
burner fi replaces with GV60 MAX systems.
Synchronizing the NT handset to the remote
control receiver
The receiver and the handset of the remote control sys-
tem must be initially synchronized before the fi rst use
of a new handset.
1. Insert alkaline batteries in the remote control
receiver and handset. The receiver is located left of
the control valve under the burner module.
2. With a sharp object, press and hold the receiver's
reset button until you hear one short and one long
beeps. Release the reset button after the second
beep.
3. Within the subsequent 20 seconds, press the small
fl ame button ( ) on the remote handset until you
hear two short beeps confi rming the sychronization
is set.
This is a one time setting only and is not required when
changing the batteries in the remote receiver. The
remote control system is now ready to use.
4003044-06
© Copyright Miles Industries Ltd., 2018.
GV60NTK
Non-Thermostatic Kit
www.valorfi replaces.com
Current room
temperature
Current time
Valor
logo
only
G6R-H3D6
•
Synchronizing the receiver again with a thermostatic
handset will reactivate the thermostat, programming
and auxiliary functions.
The non-thermostatic
(NT) handset is
identifi ed with a Valor
logo only. It shows
the current time and
room temperature.
The number shown
on its back cover
label is G6R-H3D6
Back cover label