Panasonic MX-KM5080 Operating Instructions Manual page 3

● Do not operate without the Blender Jug Base and the Blender Jug in place
correctly.
● Do not operate without the Mill Container Base and the Mill Container in
place correctly.
● Do not insert fi ngers or utensils such as spoon or fork into the Blender Jug
while the appliance is operating.
● Do not remove the Blender Jug when the motor is still rotating.
● Do not push the Safety Lock Pin and any Safety Levers with any instrument
such as stick as the appliance may be switched on.
● Do not use the Mill Container if it is damaged or has visible cracks.
● Always operate the blender with the Blender Lid or the guard in position as
indicated in the instructions. Never put the hand in jar when it is placed on
the Motor Housing, if food needs to be pushed down use suitable tool e.g.
Scraper.
● Make sure the voltage indicated on the label of the appliance is the same as
your local supply.
• Also avoid plugging other devices into the same outlet to prevent electric
overheating. However, if you are connecting a number of plugs, make sure the
total wattage does not exceed the rated wattage of the outlet.
● This appliance shall not be used by children.
Keep the appliance and its cord out of reach of children. Appliances can
be used by persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and if they
understand the hazards involved.
Children shall not play with the appliance.
● Insert the Plug fi rmly.
• Otherwise it may cause electric shock and fi re caused by the heat that may
generate around the Plug.
● Clean the Plug regularly.
• A soiled Plug may cause insuffi cient insulation due to the moisture, and may
cause fi re.
● Discontinue using the appliance immediately and unplug in the unlikely
event that this appliance stops working properly.
e.g. for abnormal occurrences or breaking down:
• The Plug or the Cord becomes abnormally hot.
• The Cord is damaged or there has been a power failure.
• The Motor Housing is deformed, has visible damage or is abnormally hot.
→ Please unplug the appliance immediately and contact the Service Centre for
advice or a repair.
● Be careful if hot liquid is poured into the Blender Jug as it can be ejected out
of the appliance due to a sudden steaming.
Blender_MX-KM5080.indb 3 Blender_MX-KM5080.indb 3
WARNING
EN3
5/20/2020 3:47:13 PM 5/20/2020 3:47:13 PM