Circuit Breaker Protection; Troubleshooting - Panasonic MX-KM5080 Operating Instructions Manual

Circuit Breaker Protection

When the Circuit Breaker automatically stops the motor due to overloading, follow the below steps:
1
Switch off to reset the Circuit Breaker.
2
Reduce the ingredients to less than 1/2 of the working capacity and/or remove hard ingredients.
3
Resume blending. If the Circuit Breaker still activates, repeat step 1 - 2. Do not repeatedly reset the Circuit
Breaker.

Troubleshooting

Ensure to turn off the appliance and the power supply before taking the actions in the table below
Problems
The appliance does not turn on.
Even though the power is on, the
appliance does not start blending.
The appliance stops during blending.
The mixture in the Blender Jug is
leaking.
There is abnormal noise or vibration.
The Cutting Blades is spinning freely
without cutting.
• A "kiiiiin" sound may be heard during operation. This is normal.
• Lubrication oil might be traced on the Lower Connector but it will not affect the performance. Please wipe it.
Blender_MX-KM5080.indb 13 Blender_MX-KM5080.indb 13
Causes
The Plug is not inserted into an outlet. Insert the Plug into an outlet.
The Blender Jug or the Mill Container
is not placed correctly.
Overloaded with ingredients or
prohibited ingredients are used.
The Safety Lever is stuck.
The Circuit Breaker Protection is
activated.
• Too many ingredients or hard
ingredients are used.
Prohibited ingredients are used.
Maximum operating time is exceeded. Turn off the appliance and refer to the
The Blender Jug Base is attached
loosely.
The Blender Gasket is not installed
correctly.
The Blender Gasket is not installed.
The Safety Lever is stuck.
Too many ingredients in the Blender
Jug.
The Blender Jug Base is attached
loosely.
Ingredients are stuck to the wall of the
Blender Jug.
Quantity of the liquid is low.
Actions
Place the Blender Jug or the Mill Container
correctly.
Do not exceed the working capacity of the
ingredients and ensure that prohibited ingredients
are not used.
Disassemble the Blender Jug Base and follow the
assembly sequence (page EN6).
See "Circuit Breaker Protection".
Remove prohibited ingredients.
recommended operating time (page EN4).
Tighten the Blender Jug Base fi rmly onto the
Blender Jug.
Install the Blender Gasket correctly.
Install the Blender Gasket.
Disassemble the Blender Jug Base and follow the
assembly sequence (page EN6).
Turn off the appliance and reduce the ingredients.
Tighten the Blender Jug Base fi rmly onto the
Blender Jug.
Turn off the appliance and insert the Scraper to
circulate.
Add liquid.
EN13
5/20/2020 3:47:16 PM 5/20/2020 3:47:16 PM