Managing Device Properties; Viewing And Changing Appliance Configuration Information; Table 4.5: Viewing Appliance Information - Avocent DSR Series DSR1010 Installer/User Manual

52 DSR Switch Installer/User Guide

Managing Device Properties

Viewing and changing appliance configuration information

The DSR switch can report most device properties directly through the DSR switch web browser.
NOTE: Users can view all appliance information, but only administrators can change settings.

Table 4.5: Viewing Appliance Information

To do this:
Display the unit's name or type
Display a list of available target devices, their type
and status
Enter, change or display the unit's IP version,
network address, gateway address, subnet mask,
prefix length (if IPv6 mode), MAC address, LAN
speed, DHCP enable status, ICMP ping reply
status, SNMP enable status or primary, secondary
or tertiary DNS servers
Display the unit's current firmware revision for
application, boot and Video FPGA
Display a list of the attached IQ module and
its status
Display a list of active KVM sessions and
their duration
Display a list of active sessions
Display a list of devices attached to the DSR switch Appliance - Connections
VIew the unit's part number, serial number and
EID number
Enter or display the unit's Site, Department
and Location
Enable the Inactivity Timeout
Change the unit encryption level
Change the modem time-out settings
Select this:
Appliance - Overview
Target Devices
Appliance - Appliance Settings - Network
Appliance- Appliance Settings - Versions
Appliance - Appliance Settings - Ports - IQ modules
Appliance - Appliance Settings - Sessions - Active
Appliance - Appliance Settings - Sessions - Active
Appliance - Properties - Identity
Appliance - Properties - Location
Appliance - Appliance Settings - Sessions - KVM settings
Then click the Enable Inactivity Timeout box
Appliance - Appliance Settings - Sessions - KVM settings
Then select the level of encryption desired for keyboard/
mouse signals and then video signals
Appliance - Appliance Settings - Ports - Modern