4.
Repeat steps 1-3 for each target device in the system.
5.
Click OK in the Names dialog box to save your changes.
-or-
Click X or press
NOTE: If an IQ module has not been assigned a name, the EID is used as the default name.
To list target devices alphabetically by name:
Press
or click Name in the Main dialog box.
Alt+N
Commands Dialog Box Functions
From the OSCAR interface Commands dialog box, you can manage your DSR switching system
and user connections, enable the Scan and Broadcast modes and update your firmware.
Table 3.7: Commands to Manage Routine Tasks for Your Target Devices
Features
Broadcast
Enable
Scan Enable
User Status
Display Versions View version information for the DSR switch as well as view and upgrade firmware for
Reset PS/2
Network Ping
To access the OSCAR interface Commands dialog box:
1.
If the OSCAR interface is not open, press
2.
Click Commands to open the Commands dialog box shown in Figure 3.18.
to exit the dialog box without saving changes.
Escape
Purpose
Begin broadcasting to your target devices. Configure a target device list for broadcasting
under the Setup dialog box.
Begin scanning your target devices. Set up a target device list for scanning in the Setup
dialog box.
View and disconnect users.
individual IQ modules.
Re-establish operation of PS/2 keyboard and mouse.
Ping a specific IP address.
Chapter 3: Local Port Operation
to open the Main dialog box.
Print Screen
35