Avery Dennison Monarch 9416 XL Reference Manual page 18

This is the syntax to use when you create online configuration packets:
Syntax
{
I,
1 - 8 op tional re cords
A, pa ram e ter 1...pa ram e ter 5
B, pa ram e ter 1...pa ram e ter 5
C, pa ram e ter 1...pa ram e ter 5
D, pa ram e ter 1...pa ram e ter 3
E, pa ram e ter 1...pa ram e ter 9
F, pa ram e ter 1...pa ram e ter 5
}
Syntax for single packet
{
I,
A, pa ram e ter 1...pa ram e ter 5
}
You can also add a configuration to RAM or specify units for supply, print, margin, and cut
positions. If you use the optional parameters with the I packet, any online configuration
packets following the split vertical bar ( ) must specify distances using the selected units.
However, the test labels display the units in dots, even if you entered them in English or Metrics
units.
Syntax
{header,ID#,action,device
1. header Constant I.
2. ID# ID. Use 0.
3. action Action. Options:
A
U
4. device Storage Device. Use R (Volatile RAM).
Example
{I,0,A,N,E
C,0,25,0,0,0 }
Adds a configuration to non-volatile RAM and specifies English units. It also uses the default
contrast, moves print 0.25 inches closer to the bottom of the supply and does not change the
margin adjustment, prints at the default print speed, and uses the default printhead width.
If you do not use the optional parameters, the syntax for the online configuration packets does
not change. For example,
{I,C,0,50,0,0,0
uses the default contrast, moves print 50 dots (0.25) inches closer to the bottom of the supply
and does not change the margin adjustment, prints at the default print speed, and uses the
default printhead width.
2-4 CONFIGURING THE PRINTER
Add configuration.
Upload User Configuration.
}
Start of Header
Con fig u ra tion Header
Sys tem Setup
Sup ply Setup
Print Con trol
Mon e tary For mat ting
Con trol Char ac ters
Com mu ni ca tion Set tings
End of Header
Start of Header
Con fig u ra tion Header
Sys tem Setup
End of Header
}