Steelcase Specific Solution for Answer Curved Corner Worksurface Assembly Instructions Manual page 6

Lower Corner Worksurface onto assembled support assembly. Align pre-drilled holes in
surface underside with bracket hole configuration. Fasten worksurface to Mounting Plates 'G'
with (5) 'C' screws each. Attach surface to brackets 'F' with (1) 'A' screw each. Use (1)
Type 'A' screw for inner flange of each bracket 'E'.
Position straight surface on support assembly. Align surfaces end to
end, flush at front and rear edges. Hold in position and secure to
bracket 'E' and plate 'H' with 1 screw 'A' each. Secure surface to
brackets 'D' with (2) 'A' screws each.
Mounting Plate 'G'
Corner Worksurface
Screw 'C' (5) Places
Screw 'C' (5) Places
Mounting Plate
Mounting Plate
Straight Surface
Support Assembly
Page 6 to 6
939504848 Rev B