AT&T Merlin Legend 7102 User Manual page 5

Starting at the top of Figure 1 and continuing clockwise:
Handset
Access Codes card
Speakerphone/headset jack
Line jack
Dial pad
Recall button
Message light
Ringer volume control
Data Capabilities
By using one of the following 3 modular adapters, you can connect a personal
computer to your 7102 voice terminal. All 3 adapters contain 2 modular plugs for
connecting your PC and your 7102 voice terminal.
A 338A modular adapter can be plugged into either a wall outlet or the line jack on
1
your voice terminal.
2
A 267C modular adapter can be plugged into a wall outlet.
A 267D modular adapter can be plugged into the line jack on the back of your
3
voice terminal.
For placing and receiving calls (also known as the
receiver). You must lift the handset (go off-hook)
before you can use a feature.
A removable quick reference card on which you can
write the names and corresponding feature (access)
codes you use most.
Located on the back of your voice terminal near the
center. This jack is used for connecting a speakerphone
or a headset to your voice terminal. The jack is labeled
"OTHER." Note: Your voice terminal may not have
this jack.
Located on the back of your voice terminal just below
the center. This jack is used for connecting a line cord
to your voice terminal. The jack is labeled "LINE."
The standard 12-button pad for dialing the telephone
numbers and accessing features.
A button used in operating features, usually to obtain a
dial tone. (This button will be shown as [
remainder of this booklet.)
A red light that blinks continuously when a message
has been left for you, and flutters when you receive a
call.
A 3-position switch to control the volume for the
ringer. Slide it up (away from you) for a louder ring,
down (toward you) for a quieter ring.
] in the
Recall
2