Registration; To Register A Handset; To Select A Base - Motorola O2 Manual

10.

Registration

Up to 11 handsets can be registered to one base station. Additional handsets
must be registered to the base before you can use them.
• The instructions described below apply specifically to the handset of
this model If you wish to register another manufacturer's handset, the
instructions may vary. In this case, please refer to the instruction manual of
the additional handset.
• The System PIN is required to register or de-register handsets. The default
PIN is 0000.
10.1

To register a handset

On the base:
1. Press and hold
in registration mode for 90 seconds.
On the handset:
1. If the handset is new, the display shows
2. Display shows
3. Press OK, display shows
(default) the handset will automatically register, if the PIN has been
changed enter the system PIN and press OK.
4. When registration is complete, the display shows
Or
If the handset has already been registered to another base, the standby
display is shown. Press Menu, scroll
5. is highlighted. Press Select.
Register HS
6. Bases are displayed. If necessary, scroll
register the O2 handset to and press Select.
7. If you are replacing a base that is already indicating
the display shows
Select
8. The display shows
handset will automatically register, if the PIN has been changed, enter the
system PIN and press OK.
Note
If registration is not successful the first time, please repeat the process again in
case the base registration period ran out of time.
If there are already 11 handsets registered to the base, registration will fail. You
must de-register a handset before you can register a new one.
10.2

To select a base

You can register the handset with up to 4 bases. Once registered, you can
switch between bases, for example, bases at home and at work.
1. Press Menu, scroll
Registration
p
until the base emits a double beep. The base will remain
Press and Hold Base Find
Searching Base
Replace Base X?
Searching Base
to
Registration
D
register. Press Reg.
Please
Key.
X. If the system PIN is 0000
Handset
to
Registration
D
or to a new base you wish to
U D
Press
Yes.
X. If the system PIN is 0000 (default) the
and press Select.
Registered.
and press Select.
when you press
In Use,
39