Decoder Configuration And Operation By Client Software; Decode And Display Directly - HIKVISION DS-6900UDI Series User Manual

DS-6900UDI(B) Series HD Video and Audio Decoder User Manual
Double click the icon to run the HikCentral Professional Control Client it in your PC. In this chapter,
the basic procedure of operating the decoder by the software is described.

Decode and Display Directly

Purpose
After setting the smart wall via Web Client, the video streams from the camera can be decoded by
the configured decoding outputs, and then you can display the decoded videos on the smart wall.
Before You Start
Add the smart wall via Web Client.
The following figure shows the main interface after accessing to the software.
Click Smart Wall on the control panel to enter the Smart Wall page.
Click in the upper-right corner of the smart wall window to select a window division mode.
Display resources on smart wall.
– Display Camera on Smart Wall: Select Camera and site from the drop-down list, and double-
click a camera name or drag the camera to the layout area of smart wall to display the
camera on the smart wall.
It is only available for the central system with Remote Site Management module (based on
the license you purchased).
– Batch Display Cameras on Smart Wall: Hold the Ctrl key and select multiple cameras in an
area or different areas, and then drag them to the layout area of smart wall and click Play in
Batch to display multiple cameras on the smart wall in a batch.
– Display Signal Source on Smart Wall: Select Signal Source from the drop-down list, and drag
the signal source to display window of the smart wall.
– Display Area on Smart Wall: Select Camera and site from the drop-down list, and double-click
the area or drag the area to the layout area of smart wall to display the resources in the area
on the smart wall.
If there are multiple resources in the area, when you drag it to the layout area of smart wall,
you need to select Play in Batch or Single-Screen Auto-Switch to display each resource in one
Decoder Configuration and
Operation by Client Software
50