Camera Dimensions; Register The Product; Contact Information - FLIR Elara FR-345-EST Quick Install Manual

Important
For information about using the camera's web page to perform additional
configuration steps, see the camera's installation and user guide.
6 Attach the Camera to a Supported VMS
After you have mounted the camera and discovered or defined its IP address, you
can use VMS Discovery/Attach procedures to attach the camera to a supported
VMS.

7 Camera Dimensions

The Elara FR-345-EST camera's dimensions are:

8 Register the Product

Register your Product with FLIR at https://customer.flir.com.
For warranty information, see
center/warranty/security/flir-security-product-warranties/.

9 Contact Information

FLIR Systems, Inc.
6769 Hollister Avenue
Goleta, CA 93117
USA
Support: https://www.flir.com/support/
Elara FR-345-EST QIG Rev 110
After powering up the camera, wait 30 minutes before
commencing screening. The camera's thermal sensor needs to
stabilize. In System Settings, click Firmware & Info, and make
sure the Temperature is stable.
Side View
https://www.flir.com/support-
This document does not contain any export-controlled information.
Front View
Corporate Headquarters
27700 SW Parkway Ave.
Wilsonville, OR 97070
USA
December 2020