Connection Time Out; Controller Displays Probe Error - Camp Chef PG20CT V2 Warning & Instruction Booklet

the switch is in the on ("-") position.
2. Leave the switch in the on position for 2 minutes. The
screen may be blank but it is completing the update.
3. If display does not turn on, cycle power on the controller.
Wait 3 second in the off position. The screen should now
come on.

CONNECTION TIME OUT

1. Exit and close the APP.
2. Cycle the power on the controller.
3. Wait 1 minute and the WiFi logo on the controller will
light up.
4. At this point open the APP and follow the APP Quick Start
Guide for connection instructions.
GRILL DOES NOT HEAT UP OR DIGITAL READOUT DISPLAYS
FLAME
1. Turn Power Off
2. Check hopper for pellets
3. Check firebox to see if there are pellets in the firebox.
The easiest way to do this is to pull the burner clean-out
knob. Then remove the cup from the bottom of the grill
and check for pellets. Use a vacuum to clean-out any
pellets that may be in the bottom of the grill.
A. If there are a lot of pellets in the cup. Reinstall the cup
and close the burner clean-out, remove the grill grates,
grease tray, and heat deflector and vacuum out any
pellets in the bottom of the grill. Try restarting the grill. If
restarting the grill does not work and pellets are getting
to the fire box the heating rod may need to be replaced.
B. If there are few or no pellets in the cup then turn the dial
to the feed position and see if pellets fall out the bottom
of the burner. If there are no pellets check to see if the
auger is turning. If the auger motor is turning but the
auger is not there may be a sheared auger pin. You can
determine if the auger motor is turning by watching the
small white fan at the end of the auger motor under the
hopper. If the white fan is turning the auger motor is on.
If the white fan is turning and the auger is not you will
need to replace the auger pin.
If problem cannot be resolved please call customer service.
CONTROLLER DISPLAYS SENSOR ERROR
1. Turn the power off and unplug the grill.
2. Check to make sure the sensor inside of the grill is
connected properly to the electronic board under the
hopper.
3. Call customer service for a replacement sensor.

CONTROLLER DISPLAYS PROBE ERROR

1. Turn the power off and unplug the grill.
2. Check to make sure the sensor inside of the grill is
connected properly to the electronic board under the
hopper.
3. Call customer service for a replacement sensor.
CONTROLLER DISPLAYS OVER TEMP
1. This happens if the internal temperature of the grill
exceeds a normal operating temperature. The grill must
be cleaned before attempting to start the grill.