Table of Contents
Advertisement
Chapter 5
Setup
Borderless Mouse Switching
The function is for channel switching by the mouse cursor hitting the left or
right edge of display borders, and then the MCD-DUAL will switch to prior or
next channel.
Note1: Default setting is OFF. Borderless mouse switching is only available for
1st-tier computers.
Note2: Once the computer is powered back on from Hibernate Mode or reset
the port's resolution, you have to calibrate the mouse cursor again by pressing
Hotkey > Hotkey > H > Enter.
In This Chapter
Setup ................................................................................................................... 21
Enable Borderless Mouse Switching ................................................................... 23
Using Mouse Switching ....................................................................................... 24
Before enabling this function, you must do the following 1 setting on the
MCD-DUAL and 3 settings on your computer.
Port Configuration:
1. Press the hotkey three times to trigger the OSD.
2. On the Selection Menu, press F3. The Port Configuration Menu displays.
21
Advertisement
Table of Contents
