MshOt TP R200 Using Manual

Thermal plate

Thermal plate TP R200

Using guide

Table of Contents

Need help?

Do you have a question about the TP R200 and is the answer not in the manual?

Page 1 Thermal plate TP R200 Using guide...
Page 2 Step 1. Take of CX43 slide clip, but Step 2. Put thermal plate on the save screws 1 and 2. stage. Note: To prevent the thermal plate slipping from the stage, you can install 'Clips' comes with the package to the position 1 and 2 in above image. And clamp the thermal plate by clips. Put ring between the screws and clips and tighten install.
Page 3 Step 3. Connect thermal plate to control box by power line. Power line USB cable port - thermal plate Power line airline port - control box Then connet control box power line to electricity.
Page 4 Step 4. Self-tuning setting (Only need to do before the first time using, do not set it again in next times use) a. Power on the control box (power button is on back of e. Press till 'SV' screen turn to the of the box).
Page 5 Step 5. Adjust heating temperature you needed( ), and waiting for thermal plate actual temeprature gets to it. Note: If surrounding temperature is too low, while you need to set temprature above 30℃，please do not set it immedidately, but take 5℃ as a unit step by step. Take an example Surrounding temperature is 20℃, Target heating temperature is 37℃...