Quick Setup
CHANGE
PRODUCT SETUP
SCROLL SELECTION
PASSWORDS
SERVICE
Adjusting the sensitivity:
•
Move to the top of the map, if not already there,
by pressing the [CANCEL] key as necessary.
•
Press the [ENTER] key once.
•
Use the [ ] or [ ] keys to move the threshold
up or down. Higher thresholds give lower
sensitivity and lower ones higher sensitivity.
•
Press the [ENTER] key once to save the new
value.
Changing a product:
•
Press the [CHANGE] key once.
•
Press the [ ] or [ ] key to scroll through the
product selection to the desired product.
•
When the correct product is displayed, press the
[ENTER] key once.
Recalibrating a product:
•
Press the [CALIBRATE] key once.
•
Press the [ENTER] key once.
•
Keep passing product until the display indicates
that the calibration cycle is complete.
Setting up a new product:
•
Press the [SETUP] key once.
•
Press the [ENTER] key twice.
•
Use the [ ] and [ ] keys to select the desired
product number.
May be obtained separately as Part No. 811124 issue level A 9/8/95
Module 7005
T xxxxx S xxxxx
LOCK KEYBOARD?
SETUP
PRODUCT NO _ _
NAME _ _ _ _ _ _ _
DRY PRODUCT
FLOW LEN
DISABLE REJECT?
REJ DELAY
REJ DWELL
PV TEST SETUP
FULL CALIBRATE?
CALENDAR
MACHINE DETAILS
CALIBRATE
UPDATE?
FULL CALIBRATE?
•
Press the [ENTER] key once to save the product
number.
•
Move down through the product setup list and
adjust the values as necessary. The Flow Length
entry will only appear if a photo-eye is
connected to the system, in which case the
length to flow of the product should be entered.
*
The PV Test Setup entry will only appear if the
Performance Validation System is enabled, in
which case entries should be made in the menu
to programme the system.
•
At the bottom of the list, when 'FULL
CALIBRATE' is displayed, press the [ENTER]
key once and pass product until the display
indicates that the calibration cycle is complete.
Moving around the menu map:
•
To move into one of the four main menus,
Change, Setup, Calibrate or Results, press the
key with the menu name on it.
•
To move down the map, press the down key.
•
To move up the map, press the up key.
•
Press the [ENTER] key to move across the map
to the right.
•
Press the [CANCEL] key to move across the
map to the left.
•
To adjust a parameter shown on the display,
press the [ENTER] key to move the
right, and then adjust the setting with the [ ]
and [ ] keys.
•
Press the [ENTER] key to save a new setting.
Operator's Guide
RESULTS
RUNNING PROD
PROD NAME
X REJECTS
X GOOD PACKS
X PACK COUNT
RESET BATCH?
STATUS REPORT?
RUN PV TEST?
CONTAMINANTS
RUN ERRORS
SYSTEM FAULTS
to the
5-13