Product Information - TMC Aquarium AQUARAY MiniLED 500 Instructions For Installation And Use Manual

Caution: Always leave a drip-loop in the DC
supply cable to the lamp unit to prevent water
running down the cable and reaching the PSU (see
picture below).
- When in operation, the grooved aluminium heat
sink on the back of the lamp unit will get hot
(± 60°C) to the touch. This is normal and is an
essential feature of protecting the lamp unit from
over-heating.
Caution: Do not cover, or obstruct in any way,
the rear aluminium surface of the lamp unit which
should always have a minimum of 10mm clearance
from the nearest surface to allow free circulation
of air around it.
Caution: Operation of the lamp unit in a confined
or unventilated space, or where there is an
additional heat source, could cause the ambient
operating temperature to rise above
35°C, reducing the useable life of the unit.
- Dispose of this unit responsibly. Check with
your local authority for disposal information.
The MiniLED 500 lamp unit is
mercury free.

PRODUCT INFORMATION

- This unit is manufactured and conforms to:-
Safety: BS EN 60598-1: 2000. BS EN 60598-2-11: 2005
EMC: BS EN 55015: 2006+A2:2009.
BS EN 61000-3-2: 2006+A2:2009.
- This unit is CE approved.
Typical Installation
Aquarium
2
Drip-loop