Advertisement
Quick Links
Advertisement
Related Manuals for TMC Aquarium Reef BIO-Gro M
Summary of Contents for TMC Aquarium Reef BIO-Gro M
- Page 1 FOR ADVANCED AQUARISTS FOR ADVANCED AQUARISTS ®...
- Page 2 ENGLISH FRANÇAIS ........................................DEUTSCH ........................................ NEDERLANDS ....................................... ITALIANO ....................................ESPAÑOL ....................................... PORTUGUÊS ............................................................................. Aquarium Drip-loop Typical Installation...
- Page 3 Algae Reactors INSTRUCTIONS FOR INSTALLATION AND USE Important Safety Information - Please Read Carefully - Always isolate from the mains electricity before installing or carrying out any maintenance to the REEF BIO-Gro unit. - This product should only be used with an approved power supply unit (PSU). Failure to do so may result in serious harm to you and damage to the unit.
-
Page 4: Parts List
PARTS LIST 1. Water inlet 2. Lid 3. Lid O ring – not shown (order code 5788) 4. Water inlet 90 elbow hosetail (order code 5789) 5. AquaBar LED installation port 6. Water outlet 7. Water outlet fitting (order code 5798) 8. -
Page 5: Assembly And Installation
The REEF BIO-Gro is an advanced, compact reactor specifically designed to grow macro-algae. It incorporates a high performance LED light, using AquaRay AquaBar technology, with LED diodes selected specifically to promote optimum algae growth inside the reactor. This macro-algae can be used to reduce unwanted nutrients such as nitrate and phosphate in your reef aquarium and also help improve water quality. - Page 6 Step 5 Step 6 Install and securely tighten the water outlet Install and securely tighten the water inlet fitting (7) and water outlet pipe (8) - failure 90° elbow hosetail (4) - failure to do so to do so will result in leaks. will result in leaks.
- Page 7 Step 9 Step 10 Ensure there is adequate space in or around If you are hanging the REEF BIO-Gro on the aquarium or sump to allow the reactor the side of your aquarium or sump, tighten to be securely installed. Make certain you the hanger securing screw (14), turning in a clockwise direction.
-
Page 8: Maintenance
Step 13 Step 14 Switch on the Make sure all connections are tightly AquaBar LED secured. Switch on and slowly adjust the water flow of your pump until the correct flow is achieved. The pump flow rate should be regulated according to the amount of macroalgae in the growing chamber and the speed should be increased as the macroalgae grows. -
Page 9: Troubleshooting
TROUBLE SHOOTING Problem:Water flow through the reactor is not sufficient 1. Possible Cause: Water flow rate to the reactor is incorrect. Solution: Adjust water flow to the reactor accordingly. 2. Possible Cause: Pump is not plugged in or is not operating correctly. Solution: Refer to the instructions supplied with your pump. - Page 12 ® Tropical Marine Centre, Solesbridge Lane, Chorleywood, Hertfordshire, WD3 5SX, UK Technical Information Lines Tel: +44 (0) 1923 284151 Fax: +44 (0) 1923 285840 Open between 9am - 5pm Monday to Thursday/9am - 12pm Friday. www.tropicalmarinecentre.co.uk tmc@tropicalmarinecentre.co.uk v.1/2018...