Taking Into Operation; Unpacking And Checking; Packing For Dispatch; Plug Connections - Magnet-physik EF 14 Operating Instructions Manual

Electronic Fluxmeter

2 Taking Into Operation

This chapter gives general instructions on setting up the EF 14 fluxmeter. Instructions for
unpacking the instrument are given in chapter 2.1. Packing the device for dispatch is described
in chapter 2.2. The plug connections are described in chapter 2.3. Finally chapter 2.4 provides
instructions on how to put the device into operation.

2.1 Unpacking and Checking

Check the packaging for signs of damage. Any correspondence regarding damage (evident or
hidden) or partial loss of the consignment must be made in written form immediately after
receipt of goods. Please also inform the freight forwarder immediately.
Open the packaging. A packing list is enclosed which allows you to check that the device,
accessories and operating instructions have been received. Use the packing list to check that all
parts of the device have been unpacked. Check for damages. Make sure everything has been
removed before discarding the packaging.
If the device has been damaged in transit make sure the forwarder and insurance are informed.
Inform Magnet-Physik of the same. If there are parts or accessories missing, let Magnet-Physik
know immediately. MPS cannot accept responsibility for any missing parts if not informed
within 60 days from date of dispatch.

2.2 Packing for Dispatch

If it becomes necessary to send in the EF 14, coils or other accessories for calibration, repair or
replacement, inform Magnet-Physik before sending the parts. If an instrument is being sent in
for service, the following information is required before the repair can be started:
 Device name and serial number
 User name, company, address, e-mail address and telephone number
 Description of fault
 Description of the measuring coil used
 Description of test arrangement.
The original packaging should be used for dispatch. If this is no longer available, use a stable
cardboard or wooden box and mark it "fragile" or "sensitive electronic equipment". If the EF 14
is shipped together with a measuring coil, pack it in a way that instrument and coil cannot
damage each other. Do not place heavy measuring coils onto the EF 14.

2.3 Plug Connections

The socket for the measuring coil connection is located on the front panel of the instrument. On
the rear side, pole clamps for measuring coil connection, a plug for the serial interface, a socket
BA – no.: 100514EBA02
th
December 9 , 2020
EF 14
Page 14