General Information; Safety Instructions - Magnet-physik EF 14 Operating Instructions Manual

Electronic Fluxmeter

1 General Information

This chapter gives an introduction to the fluxmeter EF 14. The EF 14 is a multi-purpose, fully
equipped electronic fluxmeter. Depending on the measuring coil attached, various
measurements can be carried out.
If you have just received your EF 14, make sure you familiarize yourself with the safety
instruction in this chapter and the instructions for taking the EF 14 into operation in chapter 2.
The complete and detailed user information on the instrument and the measuring modes can be
found in chapters 3, 4 and 5. Chapter 6 deals in detail with the remote control of the EF 14 by
means of the serial interface. The connectors of the EF 14 are described in chapter 7.

1.1 Safety Instructions

The following general safety measures must be adhered to at all times when the device is in use,
being serviced or being repaired. Failure to observe these measures, or warnings given in other
parts of these instructions, may influence the safety standards of the construction. MAGNET-
PHYSIK Dr. Steingroever GmbH, Cologne, will accept no responsibility should the customer
neglect the prescribed safety instructions.
Special safety instructions, whose non-observance may lead to injuries and/or property damage,
as well as important hints, are marked within these operating instructions as follows:
Danger!
Means that serious bodily injury resulting in death or considerable material
damage may occur if the appropriate safety measures are not taken.
Warning!
Means that serious bodily injury or considerable material damage may occur
if the appropriate safety measures are not taken.
Caution!
Means that light bodily injury or material damage may occur if the
appropriate safety measures are not taken.
Important!
Indicates important information which is to be paid particular attention.
BA – no.: 100514EBA02
th
December 9 , 2020
EF 14
Page 6