Intended Purpose; Sources Of Danger - Magnet-physik EF 14 Operating Instructions Manual

Electronic Fluxmeter

1.1.1 Intended Purpose

Important!
It must be explicitly stated that the Electronic Fluxmeter EF 14 is to be used
only for its intended purpose.
The intended purpose of the EF 14 is the measurement of magnetic flux
and quantities that can be derived from this, by means of measuring
coils.
Every application not in accordance with this intended purpose is prohibited
and implies the deliberate dealing with non-calculable risks for both the
operator as well as the equipment.
Unauthorized reconstruction of and/or alterations to the equipment are
forbidden for safety reasons!
The instructions as stipulated in this operating manual for operation and installation are to be
strictly observed!

1.1.2 Sources of Danger

Danger!
To minimize the danger of electric shock the device casing must always be
grounded. The device must be connected to an approved 3-pole socket using
a 3-wire power cord. Care must be taken that the grounding wire is securely
connected to an electrical ground (PE).
Danger!
Under no circumstances the instrument must come into contact with liquid
mediums, such as water, oil, etc. If in spite of all precautions taken, such a
medium comes into contact with the electronics of the EF 14, there is
considerable danger for the operation of the device. In this case the device
must be shut down immediately.
The equipment must always be switched off when being cleaned.
Never clean with water! Use dry cloths only for cleaning!
Danger!
The measuring coil must never be brought into contact with an electrical
voltage conductor. The sleeve or paint on the coil surface is not an electrical
insulation. Disregard of this warning can cause danger to life of the user.
Additionally the device and the coil can be damaged.
BA – no.: 100514EBA02
th
December 9 , 2020
EF 14
Page 7