Limit Commands - Magnet-physik EF 14 Operating Instructions Manual

Electronic Fluxmeter
5
8
10 G
13 A/m
16 Oe
18 A
21 Vs/n
22 Wb/n
23 Mx/n
24 Mx
25 Vsm
26 Am²
27 Gb
Answer:
The settings for other than the listed parameters values are not defined.
If a parameter that is not valid for the selected coil is sent, then the EF 14
switches to Vs.
Write:
RANGE
Answer:
Read:
Answer:
Var. function
VAR
Write:
Answer:
Read:
Answer:
Request data from the measured data memory, parameter x: number of the
MEM
memory cell
Read:
Answer:

6.3.4 Limit Commands

BA – no.: 100514EBA02
Wb magnetic flux in Weber for all coils
T magnetic flux density in Tesla for field coil
magnetic flux density in Gauss for field coil
magnetic field strength in Ampere pro Meter for Field Coil
magnetic field strength in Oersted for Field Coil
magnetic potential in Ampere for Potential Coil
magnetic flux per turn for Surrounding Coil
magnetic flux per turn for Surrounding Coil
magnetic flux per turn for Surrounding Coil
magnetic flux in Maxwell for coils
magnetic dipole moment for Moment Coil
magnetic moment for Moment Coil
magnetic potential in Gilbert for Potential Coil
UNIT x
#RANGE x
RANGE x
?RANGE
RANGE x
#VAR 0
#VAR *x
#VAR /x
VAR NONE
VAR *x
VAR /x
?VAR
the same as for Write.
?MEM x
Value of the memory content, if the memory cell is occupied,
otherwise "void".
(x = 0...27)
Measuring range: x = -4, -5, -6, -7 (for the ranges
-4 -7
10 to 10 Vs)
x = -4, -5, -6, -7
x = -4, -5, -6, -7
disable function
multiply the measured value by x
divide the measured value by x
function disabled
the measured value is multiplied by x
the measured value is divided by x
th
December 9 , 2020
EF 14
Page 44