Grundig Sonoclock 590 Manual page 10

OPERATION
Displaying the alarm times
Depending on the setting
time 2 is displayed.
1 Press »ALARM« and hold it down.
– Display: the last alarm time set.
2
Release »ALARM« to end the display of the alarm time.
– Display: the current time.
Note:
If the »AL 1 1+2
cannot be displayed.
Alarm with radio station
1 Press »RADIO
2 Set the frequency band with
3 Find and tune the station using the
4 Set the required alarm volume with
5 Select the radio alarm (» « ) with »
– The device switches the radio on at the set times (alarm duration 59
minutes).
Alarm with signal tone
1
Set the signal alarm (» « ) with »
– The device switches on at the set alarm times with the alarm signal
(alarm duration 59 minutes).
Interrupting the alarm
1
Press »SNOOZE« while the alarm is sounding.
– The alarm (signal or radio) stops.
– The alarm comes again at 6-minute intervals (alarm duration - 59
minutes).
_____________________________________
1« or
(»AL
2« sliding switch is set to »1+2«, the alarm times
ON« to switch on the device.
»FM
2«) either alarm time 1 or alarm
»AL
MW«.
»- TUNING +«.
»- VOLUME +«.
«.
«.
ENGLISH 21