SAFETY AND SET-UP ____________________________ This device is designed for the playback of audio signals. Any other use is expressly prohibited. Protect the device from moisture (water drops or splashes). Do not place any vessels such as vases on the device. These may be knocked over and spill fluid on the electrical components, thus presenting a safety risk.
Page 5
OVERVIEW ______________________________________ See the figure on page 2. Controls on the top SLEEP Activates the sleep timer. To display the current sleep timer setting. TIME Press and hold down: to set the time. ALARM Press and hold down: to set the alarm time. Press briefly: to display the alarm time.
Page 6
OVERVIEW ______________________________________ Controls on the right side + VOLUME - Adjusts the volume. AL 1 1+2 2 Sliding switch, switches between alarm time 1 or 2; activates alarm time 1 or 2 or 1+2. Headphone jack for connecting a stereo headphone set with a jack plug (3.5 mm).
Check that the mains voltage on the type plate (on the bottom of the device) corresponds to your local mains supply. If this is not the case, contact your specialist dealer. Plug the mains cable into the socket (230V ~ , 50 Hz Sonoclock 590, 230V ~ , 50/60 Hz Sonoclock 590 Q). Caution: The device is connected to the mains with the power plug.
OPERATION _____________________________________ Switching on and off ON« to switch on the device. Press »RADIO Press » « to switch off (stand-by) the device. Radio operation For the best FM (VHF) reception, it is sufficient to direct the wire antenna accordingly. Tuning radio stations MW«.
Page 10
OPERATION _____________________________________ Displaying the alarm times 1« or 2«) either alarm time 1 or alarm Depending on the setting (»AL »AL time 2 is displayed. Press »ALARM« and hold it down. – Display: the last alarm time set. Release »ALARM« to end the display of the alarm time. –...
OPERATION _____________________________________ Cancelling the alarm for the day During the alarm press » «. – The alarm (signal or radio) stops, the alarm stand-by retains the set time for the next day. Cancelling/activating alarm stand-by AL OFF Switch » « to » «...
OPERATION _____________________________________ Note: If only »SLEEP« is pressed for longer than 3 seconds, the remaining switch-off time reduces in 1 minute steps. Release »SLEEP« to end the setting. – After the selected switch-off time has elapsed, the device switches off automatically.
INFORMATION _________________________________ Environmental note This product has been manufactured with high quality parts and materials which can be reused and are suitable for recycling. Therefore, do not dispose the product and battery with nor- mal domestic waste at the end of its service life. Take it to a collection point for the recycling of electrical and electronic equipment.
This device conforms to the safety regulation VDE 0860 and therefore the international safety regulation IEC 65. Power supply: 230 V, 50 Hz (Sonoclock 590) 230 V, 50/60 Hz (Sonoclock 590 Q) Max. power consumption: < 3,5 W (operation), < 2 W (standby) Output:...
Need help?
Do you have a question about the Sonoclock 590 and is the answer not in the manual?
Questions and answers
Transformer