3.
Remove the speaker from the computer (3).
NOTE:
installation.
Reverse this procedure to install the left speaker.
Power connector cable
To remove the power connector cable, use this procedure and illustration.
Table 5-6
Power connector cable description and part number
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the power connector cable:
1.
Remove the two Phillips M2.0 × 5.0 screws (1) from the power connector bracket.
2.
Remove the bracket (2).
3.
Disconnect the cable from the system board (3).
4.
Remove the cable from the clip on the side of the fan (4).
Be sure that the rubber gaskets are installed in the mounting holes in the speaker (4) before
Bottom cover on page
Preparation for disassembly on page
30).
Battery on page
Component replacement procedures
Spare part number
M57215-001
30).
31).
37