HP OMEN 16 Maintenance And Service Manual page 61

1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the solid-state drives (see
5. Remove the power connector cable (see
6. Remove the heat sink (see
7. Remove the fans (see
8. Remove the system board (see
Remove the display assembly:
1. Remove the antenna cable from the computer by releasing the tape (1), and then removing the
antennas cable from the computer (2).
2. Remove the six Phillips M2.5 × 3.5 screws (1) that secure the display assembly to the computer.
3. Open the display to about 45° (2), and the close the display (3). This opens the hinges.
Preparation for disassembly on page
Bottom cover on page
Battery on page 31).
Solid-state drive on page
Power connector cable on page
Heat sink on page 38).
Fans on page 40).
System board on page
30).
33).
37).
44).
Component replacement procedures
30).
53