TMC Aquarium V2 Auto Top Up Compact Manual page 6

In most aquarium systems the loss of water from the aquarium is mainly due to factors such
as evaporation. If evaporated water is not regularly replaced, problems can occur and the
water quality of the aquarium may be compromised. The V Auto Top Up Compact System
2
provides a simple and hassle-free solution to automatically top up any water lost from the
aquarium or sump through evaporation and to create an advanced professional set-up.
PARTS REQUIRED FOR INSTALLATION AND OPERATION
1. Residual current device (RCD) with a rated residual operating current not exceeding 30mA.
ASSEMBLY
The V Auto Top Up Compact System is supplied almost fully assembled. After unpacking and
2
before installation you must:-
1. Ensure that the float switch guard is correctly secured on the mounting bracket (see photo 1).
2. Connect all components to the component connection cable (see photo 2 or 3).
3. Attach and secure one end of the flexible top up hosing to the pump outlet (see photo 4).
4. Carefully cut the flexible top up hosing and install the anti-siphon valve (see diagram below)
5. Connect the power supply unit (PSU).
2
1
4
3
4