Task Force Tips SHO-FLOW 1 Instructions For Safe Operation And Maintenance page 10

Link Retain Time
Anytime you stop the fl ow (eg. to talk or adjust the set-up), the power stops and the
Bluetooth link is broken. Typically, it should take less than 5 seconds to reconnect
automatically.
If you plan to start and stop the fl ow often and do not wish to wait the 5 sec for the
automatic reconnection to occur, it is possible to set a Link Retain Time. Doing this
keeps the SHO-FLOW powered and the Bluetooth connection active when water is
not fl owing through the device for a short amount of time.
Flow meters come factory equipped with a standard non-rechargable lithium-ion
battery having a 10-year storage lifespan, which can be used to extend Bluetooth
connection times. The default setting for this battery is the disabled condition
(Bluetooth stops immediately after fl ow stops). This battery can be enabled in app
to allow for the Bluetooth connection to be maintained when water is not fl owing.
Storage in direct sunlight or hot conditions can shorten battery life. Consult factory
when battery replacement is necessary.
The current setting for Link Retain Time is displayed below the drop down.
The time can be set by selecting an option from the drop down:
• 0 sec (Default)
• 10 sec
• 30 sec
• 60 sec
Firmware Revision
When connected to a SHO-FLOW the Firmware Revisions will read what code
revision is currently on the board. App Revision will always be displayed.
Reset Totalizer
When resetting the totalizer to zero, a connection to the desired SHO-FLOW is
required. Press the Reset button and the totalizer will begin again at zero.
©Copyright Task Force Tips LLC 2019
10
LIE-100 December 30, 2019 Rev04