Fm Operation; Switching From Dab To Fm Mode; Auto Scan; Manual Scan - Sandstrom Lifestyle DAB HiFi Instruction Manual

FM Operation

Switching from DAB to FM Mode

During ON mode, to switch the unit to FM mode, tap the FUNCTION icon on the unit or
press the FUNCTION button on the remote control repeatedly to select FM. The display will
show FM and the frequency.

Auto Scan

To search for an FM station automatically, tap the
/SCAN button on the remote control to start the auto scan forward. Tap and hold the
/SCAN icon on the unit or press and hold the
to start the auto scan reverse. Once a station has been found, the scanning will stop
automatically.

Manual Scan

To search for FM stations manually, press the SKIP/TUNE/SEARCH
unit or the remote control repeatedly until your desired frequency is reached.
With FM radio it may be necessary to fine tune each station by pressing the SKIP/TUNE/SEARCH
buttons on the unit or the remote control repeatedly. Each press will adjust the frequency
by 0.05MHz. If reception is still poor adjust the position of the aerial or try moving the radio to
another location.

Audio Mode

Press the SELECT/MONO/ST. button on the remote control to toggle between the Auto or
Mono selection.
The unit will automatically switch between stereo and mono in Auto mode depending on the
station, but you can override this and switch this function manually to set to Mono mode. This is
helpful when receiving poor signal reception.

Storing Stations

You can store up to 30 of your favourite stations to the memory. This will enable you to
access your favourite stations quickly and easily.
1. To store a preset, you must first be listening to the station that you would like to save.
Press the DISPLAY button on the unit or the remote control. The "Preset Empty #" will
show on the display and the preset number will flash.
Press the SKIP/TUNE/SEARCH
2.
select your desired preset station number and then press the DISPLAY button on the
unit or the remote control to confirm.
The station will be stored and the screen will then show "Preset # Stored".
3.
/SCAN icon on the unit or press the
/SCAN button on the remote control
buttons on the unit or the remote control to
buttons on the
21