Ingersoll-Rand SS100 Series Maintenance Information

Ingersoll-Rand SS100 Series Maintenance Information

Air starters for internal combustion engines

Advertisement

Quick Links

48393383
Edition 01
April 2012
Air Starters for
Internal Combustion Engines
SS100 Series
Maintenance Information
Save These Instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SS100 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Ingersoll-Rand SS100 Series

  • Page 1 48393383 Edition 01 April 2012 Air Starters for Internal Combustion Engines SS100 Series Maintenance Information Save These Instructions...
  • Page 2 General Instructions 2. In a press, place rotor (11) with pinion end down supporting the body of the rotor. Place rear end plate (7) over rotor (11) and with 1. Reference Parts Information Manual for item number call outs. 0.003” thick shims between rotor and rear endplate, fully press 2.
  • Page 3 Pinion removal With fully assembled starter 1. Extend drive pinion (33) by applying 60-90 psig air to one “I” port while plugging both “O” ports and the remaining “I” port. See Dwg. 48404032 SH5. Orient motor dowel hole and inlet side of motor housing “I”...
  • Page 4 Lubrication & Torque Do not lubricate O-Ring. Install Dry. 23 X Tighten to 5 - 7 Nm [44 - 62 Lb - In] Add 65 cc (2.2 oz) Ingersoll Rand #130 Grease to gearing Lubricate seal Lip with O-Ring Lubricant Coat Splines and Ball with Ingersoll Rand #130 Grease Coat Splines with...
  • Page 5 Notes:...
  • Page 6 Notes:...
  • Page 7 Notes:...
  • Page 8 www.ingersollrandproducts.com © 2012 Ingersoll Rand Company...

Table of Contents