Table of Contents
Advertisement
By default, the R A I D D i s k
field is grayed out under the following conditions:
•
The disk does not meet the minimum requirements for use in a RAID
array.
•
The disk is not large enough to mirror existing data on the primary
drive.
•
The disk has been selected as the Hot Spare for the RAID array.
•
The disk is already part of another array.
4.
Repeat step 5 to add the other disks to the volume.
5.
When done, press <C> to create the array, then select S a v e
c h a n g e s t h e n e x i t t h i s m e n u
c h a n g e s t h e n e x i t t h i s m e n u
c h a n g e s t h e n e x i t t h i s m e n u
c h a n g e s t h e n e x i t t h i s m e n u.
c h a n g e s t h e n e x i t t h i s m e n u
6.
The utility creates the array.
A S U S D S B F - D S e r i e s
A S U S D S B F - D S e r i e s
A S U S D S B F - D S e r i e s
A S U S D S B F - D S e r i e s
A S U S D S B F - D S e r i e s
R A I D D i s k
R A I D D i s k field shows N o
R A I D D i s k
R A I D D i s k
N o
N o before array creation. This
N o
N o
S a v e
S a v e
S a v e
S a v e
5 - 4 5
5 - 4 5
5 - 4 5
5 - 4 5
5 - 4 5
Advertisement
Table of Contents
