Peripheral Devices Configuration - Asus DSBF-D Series Manual

Legacy USB Support [Enabled] Legacy USB Support [Enabled] Legacy USB Support [Enabled]
Legacy USB Support [Enabled] Legacy USB Support [Enabled]
Allows you to enable or disable support for USB devices on legacy
operating systems (OS). Setting to [Enabled] allows the system to detect
the presence of USB devices at startup. If detected, the USB controller
legacy mode is enabled. if no USB device is detected, the legacy USB
support is disabled. Configuration options: [Disabled] [Enabled]
4.4.5 4.4.5 4.4.5

Peripheral Devices Configuration

Peripheral Devices Configuration Peripheral Devices Configuration
4.4.5 4.4.5 Peripheral Devices Configuration Peripheral Devices Configuration
This menu shows the peripheral devices configuration settings. Select an
item then press <Enter> to display the configuration options.
Advanced
Serial port A
Base I/O address
Interrupt
Serial port B
Mode
Base I/O address
Interrupt
Parallel port
Base I/O address
Interrupt
Mode
DMA channel
Floppy disk controller
F1:Help
ESC: Exit
Serial port A [Enabled] Serial port A [Enabled]
Serial port A [Enabled] Serial port A [Enabled] Serial port A [Enabled]
Allows you to configure serial port A.
Configuration options: [Disabled] [Enabled]
Base I/O address [378] Base I/O address [378] Base I/O address [378]
Base I/O address [378] Base I/O address [378]
Allows you to select the base I/O address for serial port A.
Configuration options: [3F8] [2F8] [3E8] [2E8]
Interrupt [IRQ 4] Interrupt [IRQ 4] Interrupt [IRQ 4] Interrupt [IRQ 4] Interrupt [IRQ 4]
Allows you to set the interrupt for serial port A.
Configuration options: [IRQ 3] [IRQ 4]
Serial port B [Enabled] Serial port B [Enabled]
Serial port B [Enabled] Serial port B [Enabled] Serial port B [Enabled]
Allows you to configure serial port B.
Configuration options: [Disabled] [Enabled]
4 - 2 4 4 - 2 4
4 - 2 4 4 - 2 4 4 - 2 4
PhoenixBIOS Setup Utility
Peripheral Devices Configuration
[Enabled]
[378]
[IRQ 4]
[Enabled]
[Normal]
[2F8]
[IRQ 3]
[Enabled]
[378]
[IRQ 7]
[ECP]
[DMA 3]
[Enabled]
↑ ↑ ↑ ↑ ↑ ↓ ↓ ↓ ↓ ↓ : Select Item
→← →←
→← →←: Select Menu →←
Enter: Select Sub-menu
-/+: Change Value
C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p
C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p C h a p t e r 4 : B I O S s e t u p
Item Specific Help
F9: Setup Defaults
F10: Save and Exit