Is There A Checklist I Can Run Through When My Controller Doesn't Connect To Wireless - Hunter Hydrawire Owner's Manual

the bottom left side of the screen.
NOTE: You need to click on the network name to see the signal strength and then click confirm if you want to
select that network. The arrows are used to scroll up and down if you have more connections than the screen
can display. You will still need to click your chosen network before clicking CONFIRM.
Is there a checklist I can run
through when my controller
doesn't connect to wireless?
Check that your wireless router is powered on.
1.
Make sure that your controller is close enough to the wireless access
2.
point/router.
Make sure that the router has 2.4GHz Wi-Fi enabled. The controller will
3.
connect to 2.4GHz 802.11b/g wireless access points; some routers are
set to accept 5GHz only.
Check that the security mode for both your wireless router and controller
4.
are the same. Hydrawise strongly recommends WPA2 personal for both
the wireless router and controller. If your router is not configured for this,
try changing the security mode to WPA2 personal.
Navigate to the Network Settings page on the controller. Look to see if
5.
the signal icon on the lower right-hand area of the screen is blinking or if it
is solid green. If it's blinking, that means it's trying to connect. If it's solid,
Copyright 2021 Hunter Industries. All Rights Reserved. 22