Hunter Hydrawire Owner's Manual page 18

6. Reset Modem/Router - Unplug for 15-20 seconds. Next, plug back in and wait 2-3
minutes. Repeat these steps two more times. Check Server Status. This will refresh
the connection to an extender if you have one installed.
7. Reset Extender (if have one) - Reset extender as well to refresh the IP settings.
8. Check Network Settings - The following Wi-Fi requirements apply to your Hunter
Hydrawise-ready controller.
Wi-Fi Checklist:
Network Types
Bandwidth
Router Channel
Security Type
Guest Networks/Networks with portal page
login
Mac Address (If Needed)
Outbound Ports
Inbound Ports
Testing with Hot-spot - Depending on your smartphone, please use either guide below:
Copyright 2021 Hunter Industries. All Rights Reserved.
Hunter HC controller is 802.11 B/G
Hunter WAND controller is 802.11 B/G/N
Hunter Pro-HC controller is 802.11 B/G/N
Hunter HPC controller is 802.11 B/G/N
Hunter HCC controller is 802.11 B/G/N
2.4 GHz only.
Not compatible with 5 GHz
Set between 1-11
WPA or WPA2
Not compatible
HC - Enter 001e followed by serial
number (e.g., 001e05fb90ce)
HCC/HPC/PRO-HC/WAND - Enter f8f0
followed by serial
number (e.g., f8f005fb90ce)
Secure MQTT (TCP Port 8883)
HTTPS (TCP Port 443)
NTP (UDP Port 123)
DNS (TCP and DNS Port 53)
None
18