Troubleshooting - Audiovox BT1611i Owner's Manual

BT1611i

TROUBLESHOOTING

CD Player Error Codes
If a problem should develop while operating the
CD player, an error code (ER-1, ER-2, etc.)
may appear on the display panel. This can
indicate a number of problems with the unit,
including a mechanical error or an error in the
microprocessor control of the player. If an error
code should appear, try ejecting and reloading
the disc into the player. While the disc is out of
the unit, make sure it is clean and undamaged,
and then load it correctly. If this does not solve
the problem, pressing the RESET button (11)
may help, but will erase the time and preset
memory (see "Reset Button" on page 10). If the
suggested measures do not solve the problem,
contact an approved warranty station near you
for further assistance.
Potential Errors
Problem Cause
Does not No power to Check connec-
operate yellow wire; no tion and/or vehi-
(display power to red cle fuse with
does not wire test light.
light)
Inline fuse Replace fuse.
blown
No power Inline fuse Check/replace
to unit blown fuse.
Not all Incorrect Check splices
speakers splices or con- and connec-
operate nections tions.
Speaker wires Check splices
shorting to and insulate all
chassis ground bare wires.
or to each other
Blows Power wire Make sure wire
fuses shorting to is not pinched.
ground
Speaker wires Make sure wire
shorting to is not pinched.
ground
Incorrect fuse Install fuse of
or fuse too correct rating.
small
CD skips Receiver mount Check mounting
too much is not solid or and backstrap
backstrap is not and tighten if
secure needed.
29
Corrective
Action