Making An Outgoing Call; Call Transfer - Audiovox BT1611i Owner's Manual

BT1611i
NOTE: When a call comes in during stand-
by mode (ignition on/power off), the head
unit will turn on automatically so you can
accept/reject the call.
NOTE: When a call comes in during talking
mode, the OPEN/EJECT button (31)
becomes deactivated.
Answering an Incoming Call
To answer the incoming call, press the AUDIO
CONTROL (DIAL) button (3).
NOTE: During an incoming call, the audio
output is muted and a ringtone is played. CD
play is paused.
Use the AUDIO CONTROL (3) to adjust the
volume during your phone conversation. During
an active call, the LCD will display "Phone
>>>>" followed by the the elapsed call time.
To end the conversation, press the B (CLEAR)
button (5).
Rejecting an Incoming Call
Press the B (Clear) button (5) to reject an
incoming call.

Making an Outgoing Call

1. Press the AUDIO CONTROL button (4) to
begin an outgoing call. The LCD will dis-
play and a cursor will
blink while waiting for the phone number
entry.
2. Turn the AUDIO CONTROL to select 0-9,
*, and # to input the phone number,
pressing the AUDIO CONTROL to confirm
each selection. Press the B (CLEAR)
button (5) to clear the last digit, or use the
Up Tuning (14) or Down Tuning (13)
buttons to move the cursor back or
forward to the incorrect input digit and then
press B.
3. After entering the phone number, press
and hold the AUDIO CONTROL or press
the MODE button (2) to dial the call.
NOTE: The audio output will only be muted
after the PHONE button is pressed to dial
the outgoing call.
NOTE: During an outgoing call or during
talking mode, the OPEN/EJECT button (31)
becomes deactivated.
25
Use the AUDIO CONTROL (3) to adjust the
volume during your phone conversation. To end
the conversation, press the B (CLEAR) button
(5).
If the ignition is turned off during a call, the unit
will remain on, allowing you to complete the
call, until you press the B (CLEAR) button to
turn the unit off. The unit will continue to
operate on battery power until it is turned
off.

Call Transfer

While talking, to transfer audio from the head
unit back to the mobile phone, press the MODE
(Transfer) button (2). The LCD will display
for 3 seconds.
• When making an outgoing call, it's not
possible to transfer the call if it is not yet
answered. You can only transfer a call
after it has been answered.
• The time it takes to transfer the call back
to the phone will vary depending on your
phone model.
NOTE: The BT1611i can only handle one call
at a time, two lines cannot be active at one
time even if your phone has call waiting.