Using A Usb Device Or Sd Card - Audiovox BT1611i Owner's Manual

BT1611i

USING A USB DEVICE OR SD CARD

Loading a USB Device
USB devices can be played through the USB
connector on the front panel. To access files on
a USB device, insert the USB device as
indicated below:
BT1611 MP3/WMA RECEIVER
SUB
RECORD
BASS
NOTE: Never detach the
front panel while a USB
device is inserted.
After inserting an USB device containing MP3
or WMA files, "USB Host" appears on the
display and the unit will automatically scan the
card for music files and begin playback.
To eject the USB device, press the MODE
button (2) to select a different source. Pull the
USB device straight out and return the cover to
the closed position.
NOTE: Due to rapid changes in technology,
the BT1611i may not support all USB
devices, particularly those that require
driver installation. Portable hard drives are
not supported. In addition, Flash music
players take longer to read than other types
of USB devices, sometimes 20-30 seconds.
Loading an SD Card
To insert an SD card, you must first remove the
front panel to reveal the SD card slot (see
"Detaching the Front Panel" on page 9). Insert
your SD Card as illustrated below and then
TUNE
reinstall the front panel.
/
AUX IN
MENU
After inserting an SD card containing MP3 or
WMA files, "SD/MMC" appears on the display
and the unit will automatically scan the card for
music files and begin playback.
To eject the SD card, remove the front panel
and then press in on the SD card to release it.
Pull the SD card straight and replace the front
panel.
Navigating Files
Please refer to "MP3/WMA Operation" on
page 15 for information regarding directory
navigation and file searching.
Recording CD Music
Your BT1611i is equipped with a Record feature
that allows you to record music from a disc to
an SD/MMC card or USB device. To record
music, perform the following steps:
1.
2.
RESET
3.
4.
19
Insert a disc and select the track you
would like to record.
Press the RECORD button (20) to activate
the Record feature.
Turn the AUDIO CONTROL (3) to select
the USB or CARD (SD/MMC) source.
Press the AUDIO CONTROL button (4) to
begin recording.
• The unit will begin recording the
current file, starting at the beginning
of the track. The LCD will display
. Recording
will stop at the end of the file.
• The recorded information is stored in
a folder named "MY_CD" on the
destination source.
• Recording will stop and the unit will
display "Memory Full" if the selected
storage device is full.