Storage - Briggs & Stratton 20215 Owner's Manual

Elite series 2450 psi pressure washer
Hide thumbs Also See for 20215:
Table of Contents

Advertisement

Available languages

Available languages

PREPARING THE UNIT
FOR STORAGE
Water should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the
pressure washer for more than 30 days, follow this
procedure:
1.
Flush chemical injection hose by placing filter into a
pail of clean water while running pressure washer in
low pressure mode (adjustable nozzle in forward
position). Flush for one to two minutes.
2.
Shut off engine and let it cool, then remove high
pressure and garden hoses. Disconnect spark plug wire
from spark plug.
3.
Empty pump of all pumped liquids by pulling recoil
handle about 6 times.This should remove most liquid
in pump.
4.
Use PumpSaver to prevent corrosion build up and
freezing of pump.
5.
Store unit in a clean, dry area.
Protecting the Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump.This
prevents freeze damage and lubricates pistons and seals.
NOTE: PumpSaver is available as an optional accessory. It
is not included with the pressure washer. Contact the
nearest authorized service center to purchase PumpSaver.
2450 PSI Pressure Washer
To use PumpSaver, make sure the pressure washer is
turned off and disconnected from supply water. Read and
follow all instructions and warnings given on the
PumpSaver container.
You must protect your unit from freezing temperatures.
• Failure to do so will permanently damage your pump and
render your unit inoperable.
• Freeze damage is not covered under warranty.
Read and follow all cautions and warnings on the
PumpSaver can label.
• Always wear eye protection when using PumpSaver.
PumpSaver will drip from pump after treatment and
will stain wood and concrete.
• Protect surfaces from dripping PumpSaver.
NOTE: If PumpSaver is not available, draw RV antifreeze
(non-alcohol) into the pump by pouring the solution into a
3-foot section of garden hose connected to inlet adapter
and pulling recoil handle twice.
STORING THE ENGINE
See the engine owner's manual for instructions on how to
properly prepare the engine for storage.
15
CAUTION
CAUTION
CAUTION

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Elite 020215

Table of Contents