Table of Contents
Advertisement
5 - Operation
Filtered Fast Fill System
The fluid is filtered through a filling filter.
The Cam Lock coupling size is 3" and can be located on the side of the
sprayer, in the front of the sprayer or both places.
1. For easy filling, the fluid refill arm (B) can be lowered by releasing
the locking pin (A) and pulling the arm down.
2. Remove the cap from the Cam Lock and connect the hose.
3. Start the water supply or remote fill pump that will be
connected to a clean water supply.
4. Open the valve.
5. Fill Main Tank to required volume.
6. Close the Main Tank Valve.
7. Turn off water supply or remote fill pump.
8. Disconnect filling hose, replace the cam-lock cap and lift the fluid refill arm (B) to transport position.
±
WARNING! After filling, ensure that the fluid refill arm is in the upper position and the lock is engaged.
Filling of Rinse tank
The rinse tank is filled via the 2 inch quick coupler. To fill the rinse tank,
proceed as follows:
1. Attach the external hose to the rinse tank quick fill coupler on the
sprayer.
2. Start water supply or remote fill pump that is connected to a clean
water supply.
3. Open the Rinse Tank Fill Valve.
4. When Tank is full, turn off the Rinse Tank Fill Valve.
5. Turn off water supply or remote fill pump.
6. Disconnect hoses.
ATTENTION! Only fill the rinse tank with clean water. To avoid
algae developing, always drain the rinse tank if the sprayer is not
used for an extended period of time.
52
A
B
Advertisement
Table of Contents
